标准名称：	震后恢复重建工程资金初评估
英文名称：	Preliminary cost estimation of post-earthquake rehabilitation of engineering structures
中标分类：	工程建设 >> 工程抗震、工程防火、人防工程 >> 工程抗震
ICS分类：	建筑材料和建筑物 >> 建筑物的防护 >> 地震和防振
发布部门：	中华人民共和国国家质量监督检验检疫总局 中国国家标准化管理委员会
发布日期：	2011-12-30
实施日期：	2012-03-01
首发日期：	2011-12-30
作废日期：
主管部门：	全国地震标准化技术委员会(SAC/TC 225)
提出单位：	中国地震局
归口单位：	全国地震标准化技术委员会(SAC/TC 225)
起草单位：	中国地震局工程力学研究所、云南省地震局、新疆维吾尔自治区地震局
起草人：	戴君武、孙柏涛、苗崇刚、宋立军、张勇、周光全、袁一凡、郭恩栋、孙景江、张令心、林均岐、王艳茹
出版社：	中国标准出版社
出版日期：	2012-03-01
页数：	16页

本标准规定了震后恢复重建工程资金初评估的步骤、要求和方法。
本标准适用于震后恢复重建工程资金初评估。

没有内容

前言 Ⅰ 引言 Ⅱ 1 范围 1 2 规范性引用文件 1 3 术语和定义 1 4 震后恢复重建工程资金初步评估步骤 1 5 基本要求 2 6 房屋震后恢复重建工程资金初评估 2 7 基础设施震后恢复重建工程资金初评估 3 8 企业震后恢复重建工程资金初评估 4 9 震后恢复重建工程初评估资金汇总 4 10 报告内容 4 附录A(规范性附录) 震后恢复重建工程资金初评估步骤 5 附录B(规范性附录) 各类基础设施系统震后恢复重建工程资金初评估分项调整系数 6 附录C(规范性附录) 企业震后恢复重建工程资金初评估分项调整系数 8 附录D(规范性附录) 震后恢复重建工程资金初评估报告内容 9 参考文献 11

下列文件对于本文件的应用是必不可少的。凡是注日期的引用文件,仅所注日期的版本适用于本文件。凡是不注日期的引用文件,其最新版本(包括所有的修改单)适用于本文件。
GB/T18208.4—2011 地震现场工作 第4部分:灾害直接损失评估

Product Code:SAE J1752/3
Title:Measurement of Radiated Emissions From Integrated Circuits-Tem/Wideband Tem (Gtem) Cell Method; Tem Cell (150 Khz to 1 Ghz), Wideband Tem Cell (150 Khz to 8 Ghz)
Issuing Committee:Electromagnetic Radiation (Emr) Task Force
Scope:This measurement procedure defines a method for measuring the electromagnetic radiation from an integrated circuit (IC). The IC being evaluated is mounted on an IC test printed circuit board (PCB) that is clamped to a mating port (referred to as a wall port) cut in the top or bottom of a TEM or wideband TEM (GTEM) cell. The test board is not in the cell as in the conventional usage but becomes a part of the cell wall. This method is applicable to any TEM or GTEM cell modified to incorporate the wall port; however, the measured RF voltage is affected by the septum to test board (wall) spacing. This procedure was developed using a 1 GHz TEM cell with a septum to wall spacing of 45 mm and a GTEM cell with average septum to wall spacing of 45 mm over the port area. Other cells may not produce identical spectral output but may be used for comparative measurements, subject to their frequency and sensitivity limitations. A conversion factor may allow comparisons between data measured on TEM or GTEM cells with different septum to wall spacing. The IC test board controls the geometry and orientation of the operating IC relative to the cell and eliminates any connecting leads within the cell (these are on the backside of the board, which is outside the cell). For the TEM cell, one of the 50 gV?ports is terminated with a 50 gV?load. The other 50 gV?port for a TEM cell, or the single 50 gV?port for a GTEM cell, is connected to the input of a spectrum analyzer or receiver that measures the RF emissions emanating from the IC and coupled onto the septum of the TEM cell.